![Fortinet vpn client set inactivity timeout](https://knopkazmeya.com/21.png)
![fortinet vpn client set inactivity timeout fortinet vpn client set inactivity timeout](https://3.bp.blogspot.com/-N6bWKAQyJaQ/VTfk0OaRKGI/AAAAAAAADK8/biCusLGD_K4/s1600/diagram.jpg)
In PanGPS.log the reason IPSEC failed is because keep-alive was not received and the agent started SSL connection instead.If the VPN client is DrayTek Smart VPN client, please provide the draytek_svc.log which can be found in the installation folder. The Syslog on both Vigor Routers until the VPN disconnection occurs.ģ.
#Fortinet vpn client set inactivity timeout password#
Remote Access to both Vigor Routers: Enable "Allow management from the Internet" via and provide both Vigor Router's WAN IP, HTTP Port and Login Password for our technical support to access your router.Ģ. If none of the above improve the VPN connection stability, please provide the information below to for further analysis:ġ. Please plug in the power cord and see if it can stabilize the VPN connection. Ensure the battery is enough on the VPN client computersīattery-powered computers may experience unexpected VPN disconnects when the operating system starts saving power for applications. If the disconnection still occurs at the key renew time, we may configure the lifetime to a shorter one for a try. Please use the same key lifetime setting on Vigor Router and the remote VPN server. An IPsec Re-key failure could be caused by the mismatched Key Lifetime setting on both VPN routers. 1 hour, the disconnection may be due to an IPsec Re-key failure. If the IPsec VPN disconnects on a certain interval, e.g. Check if the IKE Key Lifetime setting is the same on both VPN routers
![fortinet vpn client set inactivity timeout fortinet vpn client set inactivity timeout](http://cdn.canadiancontent.net/t/screenshot/750/forticlient.jpg)
Since most Vigor Routers support Dead Peer Detection(DPD) to detect IPsec connection, it is recommended NOT to enable the Ping to Keep Alive option if you are having VPN disconnecting problem. If the Ping Target IP is not responding Ping, IPsec VPN connection will drop every 60 seconds. “Ping to Keep Alive” option is using ping to detect if the IPsec connection is alive or not. Similarly, If you don't want the VPN server to disconnect the connection for not detecting traffic, set "Idle Timeout" to 0. Set "Idle Timeout" to 0 for Dial-in profiles (VPN server)
![fortinet vpn client set inactivity timeout fortinet vpn client set inactivity timeout](https://help.fortinet.com/fmgr/50hlp/56/5-6-2/Resources/Images/Central%20VPN_FMG/Create%20SSL%20VPN%20Portal%20Profile.png)
If you don't want the VPN to be disconnected, enable "Always on" for Dial-out profiles. It means the router will disconnect the VPN connection if it did not detect any traffic over the VPN connection for 300 seconds. Enable "Always On" for Dial-out profiles (VPN clients)įor LAN-to-LAN profiles, the Idle Timeout is set to 300 seconds by default. Go to Online Status page to check the Up Time of both VPN Routers' WAN interface to see if this is the problem. VPN is established through the Internet connection therefore, it will be unstable if the WAN connection of one of the VPN Routers is not stable. If the VPN tunnel disconnects frequently, you may take the following steps to troubleshoot.
![Fortinet vpn client set inactivity timeout](https://knopkazmeya.com/21.png)